Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Thanks Tree3Thanks
Reply
 
LinkBack Thread Tools Display Modes
December 2nd, 2016, 04:26 PM   #1
Junior Member
 
Joined: Dec 2016
From: Norway, Bergen

Posts: 7
Thanks: 1

I Ride: Husaberg FE570
Problem with start, will start but not run, just for seconds..

Hey, has a fe570 09 mod.

it suddenly stopped for me the other day and found out the day after the battery was the problem.

The bike started after new battery, but now it starts, but only for a few seconds.

has anyone an idea what it could be?
Lielie95 is offline  
 
December 3rd, 2016, 09:20 AM   #2
Senior Member
 
Joined: Nov 2011
From: Nordic countries

Posts: 1,051
Thanks: 475

I Ride: Two FE570 -12
Is it always the same timing on the stops? Does it happen when you move the throttle? Do you get any ecu flash codes? Can you hear the fuel pump prime when you try to restart it?

If yes on first maybe stuck/shorted roll over sensor?
If yes on second maybe tps out of position?
If yes on third please share!
If yes on maybe fuel related?
jon andersson is offline  
December 3rd, 2016, 11:19 AM   #3
Junior Member
 
Joined: Dec 2016
From: Norway, Bergen

Posts: 7
Thanks: 1

I Ride: Husaberg FE570
FE 570 09 .- the engine stop after few seonds

big thank you for your feedback

no it can vary a little but about 3-7 seconds and then dies, resumes easily, but the same thing happens ..

can provide gas, no cutting or the like.

no flash codes .. and I can hear the pump running normally. at least before the start, has not been listening about the fuel pump runs when the engine is started? but think so ...

has only owned the bike for a few months, so not so great knowledge about the biken yet. but have gone without problem since, changed oil and everything looks absolutely top out, no metal in oil or similar
Lielie95 is offline  
December 3rd, 2016, 11:32 AM   #4
Junior Member
 
Joined: Dec 2016
From: Norway, Bergen

Posts: 7
Thanks: 1

I Ride: Husaberg FE570
FE 570 09 .- the engine stop after few seonds

maybe the battery is still the problem or ?

it is a filter in the fueltank? i have not check fuelfilters or something in the injector? but very strange since it start fine and yes.
Lielie95 is offline  
December 3rd, 2016, 12:14 PM   #5
Senior Member
 
Joined: Nov 2011
From: Nordic countries

Posts: 1,051
Thanks: 475

I Ride: Two FE570 -12
If you tap the start button so the system start but the starter doesnt crank the engine you will, the first time, hear the fuel pump prime the system with pressure. If you then start the engine and stop it there should still be pressure in the fuel hose. In your case let the engine die.. So if you then tap the start button again there should only be a very short sound from the fuel pump as the system is already primed. If it is not that way and the pump work as much as the first time it might be that the pump doesnt deliver enough. And as you have a -09 that could be the case, they changed to a better pump in -11.

Or it could be clogged filters yes. You have two in the tank (one mesh under the fuel pump and a normal fuel filter in the midle of a hose). Then there is also one in the quick connect but I doubt that one is the problem.

I dont think it is the injector as then the engine should be able to idle atleast. This seems to be that the fuel system cant deliver enough when the engine is running and when the pressure is too low in the hose the engine stops.

So tap it and listen to the pump prime. That might give us a clue.
Thanks from Idle
jon andersson is offline  
December 3rd, 2016, 12:51 PM   #6
Junior Member
 
Joined: Dec 2016
From: Norway, Bergen

Posts: 7
Thanks: 1

I Ride: Husaberg FE570
FE 570 09 .- the engine stop after few seonds

tried as you said, and where everything seemed as it should be, built up pressure on first tap, and then tap on the die button, it started again without any prime loading ..?

you think i should begin with cleaning the filters in the fueltank?

it could maybe be the sensor you talk about ? i feel it die around same time , every time
Lielie95 is offline  
December 3rd, 2016, 01:22 PM   #7
Senior Member
 
Joined: Nov 2011
From: Nordic countries

Posts: 1,051
Thanks: 475

I Ride: Two FE570 -12
Yeah, disconnect the sensor and see.
jon andersson is offline  
December 3rd, 2016, 02:49 PM   #8
Junior Member
 
Joined: Dec 2016
From: Norway, Bergen

Posts: 7
Thanks: 1

I Ride: Husaberg FE570
how to disconnect it ?
Lielie95 is offline  
December 3rd, 2016, 11:51 PM   #9
Senior Member
 
Joined: Nov 2011
From: Nordic countries

Posts: 1,051
Thanks: 475

I Ride: Two FE570 -12
Sorry I didn't answer last night, I fell asleep as I was already in my bed...

Good question though. The roll over sensor is under the battery box and has a connection, and the easiest way is to lift up the batterybox (no need to remove the battery). If you want more space you can loosen the subframe, but it's not really necessary. It would be nice to get to the other end of the cable but it disappears into the loom. So it might be a good thing to check the loom for any broken/shorted cables too as there are a few places that can happen.
jon andersson is offline  
December 4th, 2016, 03:03 AM   #10
Junior Member
 
Joined: Dec 2016
From: Norway, Bergen

Posts: 7
Thanks: 1

I Ride: Husaberg FE570
FE 570 09 .- the engine stop after few seonds

Thanks for excellent feedback, i will try this later, I strongly believe that it may be the rollover sensor. but its good to have it roll sensor disconnected or is it a way and rebooting it?
Lielie95 is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
problem, run, seconds, start



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
EL start problem Tollum Husaberg 6 August 19th, 2014 12:18 PM
fs 650 '04 electric start problem kickstarter Husaberg 15 February 1st, 2009 01:49 AM
Problem with E-start vwhusaberg Electrical 1 November 3rd, 2008 03:36 PM
A problem with start freewheel Hannu Mechanical 55 May 4th, 2008 04:36 PM
kick start, electric start problem vinman1513 Mechanical 1 March 15th, 2006 01:42 PM


Facebook Twitter Google+ RSS Feed