Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
October 30th, 2016, 04:20 PM   #1
Junior Member
 
Joined: Sep 2016
From: Weaverville nc

Posts: 11
Thanks: 0

I Ride:
Hard shifting

09 450 fe. I experienced hard to shift between 2-4th. Primarily dual sporting Didn't do it all the time though. I do have recluse but even when using clutch it would be hard to shift? To complicate things it didn't do it every time? Thoughts? Thanks in advance!
400psi is offline  
 
October 31st, 2016, 12:49 AM   #2
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,655
Thanks: 447

I Ride: Husaberg FE501e 2003
second and fourth use 6th in between them as in: 4-6-2. howeever, third is on the input shaft and locks into 5th or 6th (as in 1-5-3/4-6-2) as third/fourth are combined gears and only third is activated off it it is hard to tell from outside what is wrong. after all, when you say second-fourth you are infact covering exactly half the gearbox namely;2nd, 3rd and 4th.

so from outside....can't say but at least 50% of selection problems are gearlever, gear selector related OUTSIDE the box so you could look at the selector claw for damage. the earlier bikes get burss on the claws and bind.

if the dogs were gone you would miss gears and overrev etc.

regards

Taffy
Taffy is offline  
October 31st, 2016, 03:01 AM   #3
Junior Member
 
Joined: Sep 2016
From: Weaverville nc

Posts: 11
Thanks: 0

I Ride:
thanks for the info. sorry to sound stupid but the selector claw is the end of shifter at the shaft connection correct? where do these cause binding? Thanks again
400psi is offline  
October 31st, 2016, 04:00 AM   #4
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,655
Thanks: 447

I Ride: Husaberg FE501e 2003
it doesn't matter "where" just look and you'll see a claw, just like a birds and then you'll either have chewy metal or you won't!

Taffy
Taffy is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
hard, shifting



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Shifting Lever? Biged Tech 1 April 12th, 2010 08:27 AM
hard shifting jzfe Mechanical 2 May 19th, 2008 08:04 AM
Recluse Hard Shifting aryan Mechanical 4 February 18th, 2007 07:30 AM
hard shifting up gears 3rd and 5th only 44014 Mechanical 2 October 1st, 2005 08:30 PM
Shifting problem Husabergler Mechanical 4 August 31st, 2004 06:40 AM


Facebook Twitter Google+ RSS Feed