Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Thanks Tree1353Thanks
Reply
 
LinkBack Thread Tools Display Modes
May 24th, 2021, 07:37 AM   #821
Member
 
Vandor501's Avatar
 
Joined: Jan 2019
From: Sweden

Posts: 59
Thanks: 10

I Ride: '08 FE450e Supermoto & '02 CR250R
You can foil the tank, it needs to be done properly though.
1. empty the tank and let the gases vent out and dry for at least a week, (some prefer a month)
2. Degrease properly and clean the surface.
3. Apply decals and let sit for at least 24h for the adhesive to cure.

If the tank vents gas through the plastic more than usual then use perforated decals.

This is what I'm going to try as a couple friend hav done this. If the decals bubble/peel off just remove and clean with "label-off" and retry.


Skickat från min iPhone med Tapatalk
Thanks from Dr_C and paolo6
Vandor501 is offline  
 
May 24th, 2021, 07:39 AM   #822
Member
 
Vandor501's Avatar
 
Joined: Jan 2019
From: Sweden

Posts: 59
Thanks: 10

I Ride: '08 FE450e Supermoto & '02 CR250R
FYI dekalkit.se is a good website in sweden!


Skickat från min iPhone med Tapatalk
Thanks from Dr_C
Vandor501 is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
adventures, drc, technical



Search tags for this page
Click on a term to search for related topics.
Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
The Underseat Adventures of CelticDude! CelticDude Fuel 9 September 16th, 2017 01:09 PM
Colorado 2 Day Adventures Exit Tours Marketplace 1 December 14th, 2012 07:58 AM
dr_c piston? popup Tech 8 April 22nd, 2009 04:16 AM
Jetting adventures BelgiqueBasterd Fuel 13 January 20th, 2008 11:50 AM
Dr_C tell us more about the billet rockers! LeFrog Mechanical 4 November 24th, 2007 10:48 PM


Facebook Twitter Google+ RSS Feed