Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
March 2nd, 2014, 02:27 AM   #1
Junior Member
 
Joined: Oct 2013
From:

Posts: 2
Thanks: 0

I Ride:
501 00 piston help me

please tell me! I want to replace the piston fe501 00. 94.96 to 91.94 from 93. cylinder will alter, but do not know all the sizes of the piston. height on the finger. about valves. who tried?? Prompt
tolik39 is offline  
 
March 2nd, 2014, 05:48 AM   #2
Senior Member
 
Bergini's Avatar
 
Joined: May 2011
From: Wisconsin, U.S.

Posts: 700
Thanks: 3

I Ride: 1995 dakota 408 5spd 8 3/4 rear end
Re: 501 00 piston help me

is the 91.94 piston out of the 450 or something? I don't know for sure I thought all the pistons were 95mm or 94.96,94.95,94.96 etc.....to switch to a 450 you would need a 450 rod and cylinder and piston....I thought the heads were the same from 89-98 at least maybe 89-2000 even, I could be wrong, that's just me thinking...
not sure if that's what your asking...maybe you could rephrase your question...and don't shout this time
Bergini is offline  
March 3rd, 2014, 12:46 AM   #3
Junior Member
 
Joined: Oct 2013
From:

Posts: 2
Thanks: 0

I Ride:
Re: 501 00 piston help me

cylinder repair is very expensive for me. so I want to put the sleeve and replace poreshen 91.94. problem arose in that I do not know the difference between 94.96 and 91.94. I want to know all the dimensions of the piston height 91.94. no visual comparison (((((91.94 this bucket stood on fe 501 87
tolik39 is offline  
March 3rd, 2014, 12:02 PM   #4
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,539
Thanks: 417

I Ride: Husaberg FE501e 2003
Re: 501 00 piston help me

a 400 piston will fit straight in. the deck height of all of the years is the same. the valve pockets of the pre 2001s are smaller than the 2001-3s. these have bigger pockets.

so basically, any 400, 92mm piston OK?

Taffy
Taffy is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
501, piston



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
650 piston Badvoc Mechanical 2 April 7th, 2011 04:43 AM
PISTON charlie501 Mechanical 0 September 1st, 2010 05:51 AM
Anyone need a 470 piston? Mogly406 Mechanical 0 June 27th, 2010 04:48 PM
Piston matt69 Mechanical 4 June 25th, 2009 04:44 AM
rod, HC piston for 400 Taffy Mechanical 8 February 13th, 2005 11:42 AM


Facebook Twitter Google+ RSS Feed