Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
April 9th, 2005, 12:23 PM   #1
Junior Member
 
Joined: Mar 2005
From: Ain, France

Posts: 8
Thanks: 0

I Ride:
leak on the cylinder head gasket

on the right side , i have a little leak on the cylinder head gasket. is someone can tell me how repair it . have you already see that problem?
thanks
Jean-yves is offline  
 
April 9th, 2005, 03:05 PM   #2
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,426
Thanks: 399

I Ride: Husaberg FE501e 2003
Jean

look up the 'owners doc'. the link is at the bottom of this post.

in it you'll see that it's practice to torque the head down + a few Nm. check it out. i also used a piece of plained wood, wet 'n dry and just rub it over the cylinder and the head.

the head has two inlet valve seats that protrude so you must work in a little circle around the head and then clean carefully.

try the new torque figures first!

regards

Taffy
Taffy is offline  
April 11th, 2005, 01:25 AM   #3
Senior Member
 
Husby's Avatar
 
Joined: Mar 2001
From: Lisbon - Portugal

Posts: 222
Thanks: 0

I Ride:
Probably the head have no distortion. These kind of leaks are normal due to the poor quality of the gasket sealant.
Remove the head clean the surfaces very well, reuse the gasket (if it isn't broken) apply a thin quantity of silicone RTV special for engine gaskets , mount and torque to 50, 55 nm's.

This will solve the problem.
Husby is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
cylinder, gasket, head, leak



Search tags for this page
Click on a term to search for related topics.
Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Is it possible to put the cylinder head gasket in backwards? bikemechanic53 Mechanical 4 November 15th, 2012 03:28 PM
Need 700 kit Head Gasket r1addict Mechanical 10 March 29th, 2012 05:41 PM
Head Gasket JBSracing Mechanical 0 February 5th, 2009 04:39 AM
cylinder base gasket oyk Mechanical 3 February 12th, 2006 11:11 AM
97 mm Head Gasket LINEAWEAVER Husaberg 7 September 17th, 2005 10:28 AM


Facebook Twitter Google+ RSS Feed