Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs

LinkBack Thread Tools Display Modes
June 1st, 2013, 05:34 AM   #1
Junior Member
Joined: May 2011
From: xxx

Posts: 18
Thanks: 0

I Ride:
Timing chain tensioner setup


Could someone explain in depth and in detail how one is to setup / handle / load the timing chain tensioner on 2009 FE 450 Husa? The manual reads on page 124 "Press the timing chain tensioner together completely." Next it says "Place two spacing washers or similar aids next to the timing chain tensioner piston. This ensures that, when pressed in, the piston cannot go in all the way." And then "Release the timing chain tensioner."

So which advise is correct, to compress fully or not?

Thanks, Tumpelo.
tumpelo is offline  

  Husaberg Forum > Mechanical and Technical > Mechanical

chain, setup, tensioner, timing

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
2010 FX450 timing chain tensioner too tight? Tillbuilt Mechanical 1 February 15th, 2014 09:16 AM
Assemble timing chain with new tensioner blade - fail! Johost03 Mechanical 7 February 25th, 2013 11:27 PM
Timing Chain Tensioner Fail Tamas Mechanical 9 November 29th, 2012 01:55 AM
Timing chain tensioner -09 Fourstrokeforce Mechanical 97 April 10th, 2009 08:29 PM
2002 timing chain and tensioner upgrade. BelgiqueBasterd Mechanical 1 November 12th, 2006 07:21 AM

Facebook Twitter Google+ RSS Feed