Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
December 27th, 2010, 06:13 PM   #1
Junior Member
 
Joined: Oct 2010
From:

Posts: 20
Thanks: 0

I Ride:
01 FE501 starting issues again!

Ok the starting isues are back! Dead cold the bike sitting for two weeks I turn on the choke two primer kicks with the decomp in then find TDC. I give her a good kick and she starts idles for about 20 seconds and then dies. After she quits it is almost impossible for her to start again. I did manage to get it to idle for a min or so with the choke on and gave the throttle a few twists but with the choke off if she is idiling if I even touch the throttle she dies. I have a #45 start jet in now would a #40 solve all this issue? Timing? I have no hair left!!!!! I did get some blowby oil from an overly full crankcase make its way through the carb Do I have to clean the thing out again? When will this nightmare end!

As a side note I took off the stator cover and there was condensation inside after a wash from a couple of weeks ago i took care of that but now my gasket is cut can I silicone the cover in place of the gasket?
ajw30 is offline  
 
December 27th, 2010, 09:24 PM   #2
Moderator
 
berger's Avatar
 
Joined: Apr 2002
From: Phoenix Arizona

Posts: 3,150
Thanks: 9

I Ride: 2010 FX450
Re: 01 FE501 starting issues again!

I am going to guess that after 20 or 30 seconds you will need to remove the choke (as soon as it starts 8 stroking). Keep it running with the throttle.
berger is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
fe501, issues, starting



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
IM TRYING TO FIX STARTING ISSUES ORANGEBERG Mechanical 12 February 13th, 2011 01:59 PM
2010 FE570 starting issues and fix Haskell Mechanical 2 January 13th, 2011 12:54 AM
02 FE400 Starting Issues Cuffy Mechanical 7 May 3rd, 2007 04:52 AM
auto decomp starting issues gttool Mechanical 4 November 27th, 2006 01:40 AM
issues with '95 fe501 al010101 Electrical 12 June 27th, 2006 07:18 PM


Facebook Twitter Google+ RSS Feed