Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
June 23rd, 2010, 09:21 AM   #21
Senior Member
 
Joined: May 2009
From: Ontario

Posts: 142
Thanks: 0

I Ride:
Re: New headgasket, leaking all over, is it screwed?

44nm = 33 ft-lbs

10nm = 8 ft-lbs
HeyJohnnyPark is offline  
 
June 23rd, 2010, 10:53 AM   #22
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,701
Thanks: 452

I Ride: Husaberg FE501e 2003
Re: New headgasket, leaking all over, is it screwed?

the factory had a figure up to 2003 i think and then in 2004 46 pounds foot became the norm. in the meantime dale L had been using 46 foot pounds all along so he was the daddy and the advice was good then and it's good now...

regards

Taffy
Taffy is offline  
June 23rd, 2010, 02:16 PM   #23
Junior Member
 
Joined: Jun 2010
From:

Posts: 11
Thanks: 0

I Ride:
Re: New headgasket, leaking all over, is it screwed?

Thanks for the input guys. Waiting on a ring compressor. One thing I dont have. 1/4 tq wrench would be nice.
UberDub is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
headgasket, leaking, screwed



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
I think I screwed up replacing the countershaft seal. Caffeineo Mechanical 7 October 7th, 2013 08:13 PM
Vinyl Tank Graphics, did i get screwed? Bergini Tech 22 June 26th, 2013 04:40 AM
the headgasket Taffy Mechanical 3 January 31st, 2009 02:32 PM
fe 400 headgasket Johnniep Mechanical 1 October 25th, 2008 02:49 PM
Re use of headgasket Karl Mechanical 4 August 5th, 2006 08:05 AM


Facebook Twitter Google+ RSS Feed