Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
February 16th, 2010, 12:27 AM   #1
Senior Member
 
Joined: Feb 2009
From: Birdwood South Australia

Posts: 273
Thanks: 13

I Ride: 70 degree fe450 2012 & Aprilia Dorsoduro
Star shifter roller bearing location.

After rebuilding my fs650 the gear from fist in second was a bit sharp/rough/jittery/clunky not extreme but just enough to anoying also the shift under light load from 5 to 6 was the same. Pulled it apart to check all was ok and was sure there was a extra washer under the spring shart with small bearing on it that rides on the star(not in manual picture). I found the washer, put it under the bearing arm and now the small bearing runs on the outside of the star and roll on washer lip is this correct or should it run on the edge of the star???? any one know?
birdwoodburg is offline  
 
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
bearing, location, roller, shifter, star



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Lone Star National March 28 Johnf3 Ride Reports 2 February 17th, 2010 08:10 PM
Nick Fahringer at the Lone Star Enduro 2008 Johnf3 Husaberg 0 December 13th, 2008 04:28 PM
roller bearing removal BelgiqueBasterd Mechanical 3 May 20th, 2007 11:01 AM
Fe400e 2003 Rockerarm Roller Bearing Nugs Mechanical 6 September 14th, 2005 04:30 PM
Roller bearing in wrong place? mikst Mechanical 8 October 27th, 2004 10:37 AM


Facebook Twitter Google+ RSS Feed