Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Mechanical

Mechanical Mechanical Forum - spinning bits and gyrating bobs


Reply
 
LinkBack Thread Tools Display Modes
December 6th, 2004, 04:30 PM   #1
Junior Member
 
BIGKID's Avatar
 
Joined: Dec 2004
From: auckland new zealand

Posts: 1
Thanks: 0

I Ride:
04 fe450e cylinder head

Can any body tell me the valve and port size of the fe450e cylinder head.
Is it the same head that the 550 and 650 use.
thanks bigkid
BIGKID is offline  
 
December 6th, 2004, 10:26 PM   #2
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,558
Thanks: 421

I Ride: Husaberg FE501e 2003
the 400 ran 35/27 and i think the 450 has 37/30 which is the same as the 470/501/600 (courtesy lineweaver). i don't know the cam as they have new part # codes and nobody has ACTUALLY SAID what they mean yet!

as the valves are usually seen as a rough ratio of the bore diameter and the above engines share nearly identical bore sizes that would make the valve sizes about right.

the exhaust valves are well smaller than the inlets to aid torque. however if you should desire more top speed, mr lineweaver at present has oversize SS valves for sale on this very site (da-da !!!!)

as for the ports, well if you're asking you don't need to know coz you should go measure yourself.

Taffy
Taffy is offline  
December 7th, 2004, 08:06 AM   #3
Senior Member
 
JoeUSA's Avatar
 
Joined: Jun 2001
From: Pasadena Ca.

Posts: 1,355
Thanks: 0

I Ride:
Gents,

My 04 parts Manual gives 1 part number for the cylinder head, 800.36.020.044, and shows it applies to the 450-650. The exhaust header pipes however have different part numbers for each engine size.

The intake valve is 35MM, the exhaust is 30MM for all 04 models

Joe
JoeUSA is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Mechanical

Tags
cylinder, fe450e, head



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Billet cylinder head Dr_C Marketplace 489 December 15th, 2014 02:51 AM
2012 TE 300 cylinder head dazzabb Mechanical 0 October 10th, 2011 10:13 AM
Cylinder Head Failure, Need New zb00p Mechanical 3 December 8th, 2010 10:59 AM
cylinder head spiney Mechanical 6 September 6th, 2008 11:17 PM
Cylinder head volume??? PowerFiend Mechanical 6 February 5th, 2006 02:30 AM


Facebook Twitter Google+ RSS Feed