Husaberg Forum

Husaberg Forum (http://husaberg.org/husaberg-forums.php)
-   Husaberg (http://husaberg.org/husaberg/)
-   -   Carburettor settings (http://husaberg.org/husaberg/6682-carburettor-settings.html)

klemen-SLO September 4th, 2007 01:09 AM

Carburettor settings
 
Hello.

I had to put apart a carburettor (Dellorto) of my 2001 FS650e.
Unfortunately, I have lost my notes about idling and mixture screw settings.

Does anybody know the approximate settings (how many turns)?

I think that mixture screw is around one turn, or so.

Thanks for your help.

Have a nice day.

Klemen

Gokai134 September 4th, 2007 01:21 AM

RE: Carburettor settings
 
Klemen-slo,

look into the owner-doc/carburation/dellorto
Everthing there

montibank September 23rd, 2007 10:19 PM

Re: RE: Carburettor settings
 
Quote:

Originally Posted by Gokai134
Klemen-slo,

look into the owner-doc/carburation/dellorto
Everthing there

Almost. Sometimes the simple is overlooked ... Which direction leans the polit/starting circuit is not there. Could this be added to the doc?

Taffy September 24th, 2007 03:18 AM

RE: Re: RE: Carburettor settings
 
the screw is i believe an air bleed screw so the more open you screw it = the more air enters to make it leaner.

i believe the doc dopes explain how to set the carb by ear for the first time which is how you should do it anyway (ideally).

to recap:
get it running
adjust air screw to gain highest idle
lower idle to correct rpm of 1,800rpm.
adjust air screw again
adjust idle screw again for 1,800rpm (or abouts)
test ride noting any 'bog' and adjust the air screw to eradicate this. it should take about 1/4-of-a-turn either way.

regards

Taffy

LeFrog September 24th, 2007 05:56 AM

RE: Re: RE: Carburettor settings
 
If you go to the download section at www.husaberg.se, you should be able to print the old parts manual. At the end, it tells you how many turns out for the idle and the mixture screw. Usually around 5 out (+/- 1) for the idle and between 1 1/2 and 2 out for the mixture.

Then what Taffy says.

Check the download section on this site, for the 4 videos. I think the first one shows how to adjust mixture and idle.

dsducati September 24th, 2007 11:53 AM

Round slide Dellortos use a fuel mixture adjusting screw and flat slide Dellortos use the air bleed adjusting method.
dan

Taffy September 24th, 2007 12:01 PM

i really must try and remember that. infact i'll go check the doc now coz if it's wrong in ma hea you know it'll be wrong in the doc!

ah! i had it right in the doc it's jus ma hea that needs a sortin oot!

regards

Taffy


All times are GMT -8. The time now is 03:41 AM.

Copyright © 2020 Husaberg Forum. All rights reserved.