Go Back   Husaberg Forum > Husaberg Forum > Husaberg

Husaberg Husaberg Forum - Husaberg Motorcycle Forum

LinkBack Thread Tools Display Modes
July 12th, 2020, 05:47 PM   #1
Joined: Dec 2009
From: Utah

Posts: 45
Thanks: 0

I Ride:
'11 FE390 stalling when letting clutch out

Help: 2011 FE390 dies once I put it in gear and try to let the clutch out. Has Rekluse Z-start Pro with new clutch pack. Have had no issues writing and starting since replacing clutch pack last year. Also has a recently replaced fuel pump.

Bike was having difficulty starting. Replaced the intank fuel filter and was able to get it started. Bike will idle fine while in neutral. Will idle just fine in gear if I have the clutch lever pulled in.

As soon as I let clutch out, bike immediately dies. All right because it's not supposed to stall or die with the recluse clutch. engine is fully warmed and I've even tried this with high or low idle and it does not seem to make a difference, the bike will still die when clutch is let out.

Open to any ideas.
Michelangelo is offline  
July 13th, 2020, 11:35 AM   #2
Senior Member
Joined: May 2017
From: United States

Posts: 109
Thanks: 20

I Ride:
The hoses in the tank can get kinked if they are not arranged properly so likely want to get in there and have a look. Also have a close look at the clamps you used on the high pressure in tank lines. Given that the stalling is related to release of the clutch also not a bad idea to get in there and make sure everything is ok with the recent clutch work you did.
NoClassic is offline  
July 28th, 2020, 02:17 PM   #3
Joined: Mar 2013
From: NY

Posts: 87
Thanks: 7

I Ride: 2010 FX450 2011 KTM 250XC
Check the plug boot with a meter if you get infinite reading pull the lug out with needle nose pliers then clean the carbon off . Be careful the spring will shoot the resistor out . Reassemble check the reading it should be 5kohms this has happened to 4 bikes that myself and friends have

cambo is offline  

  Husaberg Forum > Husaberg Forum > Husaberg

clutch, fe390, letting, stalling

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Want To Buy: Fe390 outer clutch cover jbpetkov Want To Buy 0 May 11th, 2020 01:42 PM
Weird stalling issue FE390 TavisB Mechanical 21 March 13th, 2020 12:21 PM
fe390 stalling and won't restart, fuel filters? wowboyz Fuel 1 January 22nd, 2016 12:13 AM
FE390 Clutch Fluid JohnnyQuest Mechanical 6 April 6th, 2011 06:32 PM
FE390 2011 Stalling Rich T Fuel 15 September 2nd, 2010 05:28 AM

Facebook Twitter Google+ RSS Feed