Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Electrical

Electrical Electrical Forum - wiring and more


Reply
 
LinkBack Thread Tools Display Modes
August 14th, 2021, 04:49 PM   #1
Junior Member
 
Joined: Apr 2020
From: argentina

Posts: 1
Thanks: 0

I Ride: Fe 450 2010
Start fail , when hot engine fe450

Hi I have a problem with My husaberg fe450 2010. When they motor is hot it have problems to start . O clean inyector change filters they pump run and give 3,5bar of pressure, check de wire...... Some idea? Thanks sorry for my Bad English
danielfrias is offline  
 
September 2nd, 2021, 03:45 AM   #2
Member
 
Joined: Mar 2013
From: NY

Posts: 91
Thanks: 8

I Ride: 2010 FX450 2011 KTM 250XC
Check the resistance of the spark plug cap should be 5k ohms if not grab the the screw tip that goes in the wire and pull it out. When you pull the screw out it will have star washers that will allow it to be pressed back in clean the carbon off the nut side then reassemble press the star washers back in place with a pick . Clean the grounds by the battery and coil install a new spark plug . Watch videos on the ktm 2012 and later they are very similar to completely understand the fuel system and trouble shoot issues
cambo is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Electrical

Tags
engine, fail, fe450, hot, start



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
2004 FE450 E-start low crank and no start votkarel Mechanical 15 May 30th, 2021 12:59 AM
FI Fail Safe if temperature off limit???HELP naov Cooling Systems 6 December 2nd, 2013 05:57 AM
Timing Chain Tensioner Fail Tamas Mechanical 9 November 29th, 2012 01:55 AM
Of all things to fail on the trail... No Spark! KustomCandy Electrical 5 March 23rd, 2010 09:18 AM
main bearing fail vote tolis Mechanical 1 October 24th, 2008 03:03 PM


Facebook Twitter Google+ RSS Feed