Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Electrical

Electrical Electrical Forum - wiring and more


Thanks Tree4Thanks
Reply
 
LinkBack Thread Tools Display Modes
December 16th, 2020, 01:18 PM   #21
Junior Member
 
Joined: Jul 2016
From: The Netherlands, somewhere in the middle

Posts: 24
Thanks: 16

I Ride: FE390 2010
By connecting and disconnecting manually I meant that you act as the ignition switch, basically it disconnects to generate a spark.
To have a good spark the voltage must be above 11V in my recollection. So try to jumpstart with a good battery, I once just had to replace my battery and all worked like a charm again.

Last edited by Ook Peter; December 16th, 2020 at 11:51 PM.
Ook Peter is offline  
 
December 17th, 2020, 02:56 AM   #22
Senior Member
 
Alan's Avatar
 
Joined: Jul 2016
From: Australia, Beechworth, Vic.

Posts: 593
Thanks: 274

I Ride: when I can which isn't often enough. FX450, FE570
Possibly hall sensor
Alan is offline  
December 17th, 2020, 10:26 AM   #23
Senior Member
 
Joined: May 2017
From: United States

Posts: 114
Thanks: 21

I Ride:
Going to go ahead and state this again as it can cause all kind of strange behavior if bad.

Did you check the coil and primary engine harness chassis grounds?
NoClassic is offline  
December 21st, 2020, 01:16 PM   #24
Junior Member
 
Joined: Jul 2016
From: The Netherlands, somewhere in the middle

Posts: 24
Thanks: 16

I Ride: FE390 2010
AND make sure to have a new battery connected afterwards if it still does not start
Ook Peter is offline  
December 23rd, 2020, 09:02 AM   #25
Junior Member
 
Joined: Nov 2020
From: Finland

Posts: 12
Thanks: 0

I Ride:
Okay thanks for everyone's help, I found the problem and it was bad wire behind the frame so was very difficult to spot.
Vapa is offline  
December 23rd, 2020, 12:52 PM   #26
Senior Member
 
Rainerio's Avatar
 
Joined: Jun 2013
From: San Francisco CA. USA

Posts: 1,094
Thanks: 259

I Ride: 8 Berg’s 2005-2011 3 Husky’s 1986&7 2021 TE300 2009 Buell & 2006 Ducati
Had a problem with front blinkers not working. Same solution pinched wires behind Headlight. For me it was the wires were cut by steering stops

Last edited by Rainerio; December 25th, 2020 at 06:20 PM.
Rainerio is offline  
December 25th, 2020, 03:21 AM   #27
Member
 
Joined: Mar 2013
From: NY

Posts: 88
Thanks: 7

I Ride: 2010 FX450 2011 KTM 250XC
Did you take a picture of the wire . Was it due to working on the bike and accidentally pinching the wire . Did you have to remove the wire harness and open it up ? Great to hear that you figured it out
cambo is offline  
December 30th, 2020, 11:19 AM   #28
Junior Member
 
Joined: Nov 2020
From: Finland

Posts: 12
Thanks: 0

I Ride:
Yes I needed to take the gas tank off to spot the problem, unfortunately didn't take picture but the wire had just rubbed against some part and almost snapped off.
Vapa is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Electrical

Tags
2009, fe450, husaberg, spark



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
2009 FE450 Inconsistent Spark Bankohk Electrical 4 June 10th, 2020 04:35 PM
For Sale: 2009 Husaberg FE450 Pploco Classifieds 1 September 4th, 2018 12:51 AM
2009 fe390 weak spark spark falling off magnumsmydog Electrical 50 April 25th, 2018 06:48 PM
For Sale: 2009 Husaberg FE450 dgangle Classifieds 1 February 22nd, 2018 01:39 PM
No spark Husaberg FE450 -09 HusaFE450 Electrical 1 May 15th, 2013 10:55 PM


Facebook Twitter Google+ RSS Feed