Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Electrical

Electrical Electrical Forum - wiring and more


Thanks Tree2Thanks
Reply
 
LinkBack Thread Tools Display Modes
May 13th, 2019, 08:10 PM   #1
Junior Member
 
Joined: May 2019
From: Santa Rosa, ca

Posts: 14
Thanks: 0

I Ride:
2013 FE501 no spark

Hello everyone,

I recently bought a 2013 Husaberg fe501. While riding the other day the bike died on me. After loading the bike and getting it home I began trying to track down the issue. The bike turns over but I have no spark. I replaced the rectifier and battery. I am also getting 100 ohms off of the red/green pulse generator. The coil also appears to be testing within spec. This is a completely new bike to me and I am pulling my hair out trying to figure out this problem. Any help is much appreciated. Thank you all in advance!!
Kawasaki108 is offline  
 
May 13th, 2019, 11:33 PM   #2
Senior Member
 
fe600racer's Avatar
 
Joined: Jun 2004
From: australia

Posts: 402
Thanks: 16

I Ride:
Check the wire on cap properly.....then check the cap.
fe600racer is offline  
May 14th, 2019, 12:24 AM   #3
Senior Member
 
Joined: Nov 2012
From: Sweden

Posts: 595
Thanks: 521

I Ride: HB 570 FE
I have the KTM equivilalent and it died, luckily while loading it into the van, fuse gone.
Never happened before or after that, hmm. Funny thing is that on visual inspection all fuses looked good, and when resistance checking them aswell.
Replacing them did the trick.
TomTom is offline  
May 14th, 2019, 01:34 AM   #4
Junior Member
 
Joined: May 2019
From: Santa Rosa, ca

Posts: 14
Thanks: 0

I Ride:
I have checked the spark plug cap and it appears to be in spec. I tried cranking the engine with the cap off of the coil to see if the plug wire would arc to ground. No luck. Tom Tom, which fuses did you replace? The 10 amp or the 20 amp? Or all of the above? Thanks again everyone for your help and suggestions.
Kawasaki108 is offline  
May 19th, 2019, 06:47 PM   #5
Junior Member
 
Joined: May 2019
From: Santa Rosa, ca

Posts: 14
Thanks: 0

I Ride:
Hey everyone,

I replaced the coil, stator, pulse sensor and the rectifier. Still no spark!!!!! This thing is driving me crazy!!! Any help would be much appreciated.

Thanks again!
Kawasaki108 is offline  
May 20th, 2019, 12:50 AM   #6
Senior Member
 
Joined: Nov 2012
From: Sweden

Posts: 595
Thanks: 521

I Ride: HB 570 FE
The four ones under the seat near the battery.
I have ride bud with the same problem as yours on his -16 501 Husky, Ill have a chat and see if he solved it.
TomTom is offline  
May 20th, 2019, 02:17 AM   #7
Junior Member
 
Joined: May 2019
From: Santa Rosa, ca

Posts: 14
Thanks: 0

I Ride:
That would be great! I was doing further testing tonight and discovered that the 10amp fuse in position 1 (electronic control unit) is not getting any power. I checked all other fuse positions with a test light and all appear to be getting power except the slot I mentioned. Not sure where to go from here or where to look. Thanks again! I hope I’m getting closer to figuring this thing out.
Kawasaki108 is offline  
May 20th, 2019, 04:08 AM   #8
Senior Member
 
Joined: Nov 2012
From: Sweden

Posts: 595
Thanks: 521

I Ride: HB 570 FE
His problem is with the ecu unit. He tried his ecu on another identical bike and it is not responding at all i.e completely dead. So if your ecu is responding thats not it.
TomTom is offline  
May 20th, 2019, 04:18 AM   #9
Junior Member
 
Joined: May 2019
From: Santa Rosa, ca

Posts: 14
Thanks: 0

I Ride:
How would I be able to check if my ecu is responding?
Kawasaki108 is offline  
May 20th, 2019, 05:29 AM   #10
Senior Member
 
fe600racer's Avatar
 
Joined: Jun 2004
From: australia

Posts: 402
Thanks: 16

I Ride:
Try now checking the simple stuff.....wiring connections in luding handlebar kill switch etc.
fe600racer is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Electrical

Tags
2013, fe501, spark



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
2013-2014 FE501 manual endurists Service Manuals 0 August 2nd, 2016 07:12 AM
2013 FE501 Vs. 500EXC bahnsy Husaberg 2 April 1st, 2016 09:43 AM
New to me 2013 FE501 :) - Mod Plans / A Few Questions J1sgo Husaberg 5 March 9th, 2015 05:49 AM
2013 FE 450 cutting out - just dies like no fuel/spark ghunt Electrical 3 August 28th, 2013 05:31 AM
2013 FE501 or 2013 EXC500 shoey85 Husaberg 7 February 8th, 2013 06:51 PM


Facebook Twitter Google+ RSS Feed