Husaberg
Go Back   Husaberg Forum > Mechanical and Technical > Electrical

Electrical Electrical Forum - wiring and more


Thanks Tree7Thanks
Reply
 
LinkBack Thread Tools Display Modes
January 10th, 2016, 08:47 AM   #1
Junior Member
 
Joined: Dec 2015
From: Norway

Posts: 22
Thanks: 2

I Ride:
No spark fe650

Hi

I have recently bought a Husberg fe650 2003 and it doesn't start. I dont't get any spark so i was hoping someone could point out any possible solution to my problem. I don't have much experience with this, so bear with me. Thanks
hauge is offline  
 
January 10th, 2016, 09:10 AM   #2
Senior Member
 
husabutt's Avatar
 
Joined: Feb 2003
From: Escondido, Ca. USA

Posts: 3,058
Thanks: 316

I Ride: 2005 Fe450,2001 Fx470,1997 Fx600
Its more than likely your stator that has failed. These are the test values:

1999 to 2003: Black & Red 3000 Ohms
Black & Green 165 Ohms
husabutt is offline  
January 10th, 2016, 11:37 AM   #3
Member
 
clive111262's Avatar
 
Joined: Dec 2015
From: Kent

Posts: 40
Thanks: 4

I Ride: 2003 FE 501 E converted to FS 650. Honda fireblade RR03
Originally Posted by hauge View Post
Hi

I have recently bought a Husberg fe650 2003 and it doesn't start. I dont't get any spark so i was hoping someone could point out any possible solution to my problem. I don't have much experience with this, so bear with me. Thanks
Hague, I have the same issue at the moment with mine, I'm planning to test it tomorrow. If there is an issue I will send it off to Taffmister to be refurbished
clive111262 is offline  
January 10th, 2016, 02:51 PM   #4
Junior Member
 
Joined: Dec 2015
From: Norway

Posts: 22
Thanks: 2

I Ride:
Thanks!

I am not familiar with ohm testing. I have a multimeter which i have been using for Volt testing. I know it can be used for both, but i am not sure how to use it. You mention the values for black/green and black/red, am i supposed to take one pin on the the black wire and one on the green wire?
hauge is offline  
January 10th, 2016, 04:05 PM   #5
Senior Member
 
husabutt's Avatar
 
Joined: Feb 2003
From: Escondido, Ca. USA

Posts: 3,058
Thanks: 316

I Ride: 2005 Fe450,2001 Fx470,1997 Fx600
Yes. Check out You Tube. There are many videos there on how to use a multi-meter and check your stator values..
Thanks from tourist
husabutt is offline  
January 16th, 2016, 03:53 AM   #6
Junior Member
 
Joined: Dec 2015
From: Norway

Posts: 22
Thanks: 2

I Ride:
I get:
black and red: 3030 ohms
Black and green: 178 ohms

That means my stator is fine, right?

What else could it be?

hauge
hauge is offline  
January 16th, 2016, 05:42 AM   #7
Senior Member
 
Joined: Nov 2001
From: Ely, England

Posts: 15,559
Thanks: 421

I Ride: Husaberg FE501e 2003
plug cap
if the plug is wet it will stop working

only fit the green to green, red to red and the black to black. nothing else. disconnect the other (spade) black, the grey, the white and the orange. don't let the orange male bullet touch anything.

then try it.

sometimes the gray and the white are the wrong way around. sometimes the orange is always making 'dead'.

finally, your coil may have gone..... (unusual on a SEM stator. it is a SEM (black plastic) stator isn't it? or can you see all the windings and spools of copper wire?

regards

Taffy
Taffy is offline  
January 16th, 2016, 09:53 AM   #8
Senior Member
 
FE350's Avatar
 
Joined: Apr 2014
From: Chilliwack, BC, Canada

Posts: 689
Thanks: 252

I Ride: 2014 FE350, Beautiful Blonde
plug cap
if the plug is wet it will stop working

only fit the green to green, red to red and the black to black. nothing else. disconnect the other (spade) black, the grey, the white and the orange. don't let the orange male bullet touch anything.

then try it.

sometimes the gray and the white are the wrong way around. sometimes the orange is always making 'dead'.

finally, your coil may have gone..... (unusual on a SEM stator. it is a SEM (black plastic) stator isn't it? or can you see all the windings and spools of copper wire?

regards

Taffy


Only when its been worked on at Taffmeister's LMAO
FE350 is offline  
January 16th, 2016, 11:20 AM   #9
Junior Member
 
Joined: Dec 2015
From: Norway

Posts: 22
Thanks: 2

I Ride:
Originally Posted by Taffy View Post
plug cap
if the plug is wet it will stop working

only fit the green to green, red to red and the black to black. nothing else. disconnect the other (spade) black, the grey, the white and the orange. don't let the orange male bullet touch anything.

then try it.

sometimes the gray and the white are the wrong way around. sometimes the orange is always making 'dead'.
I am not sure that i understand what you mean here. I understand what i should connect and disconnect but what do you mean by try it? What do you mean by orange making dead.

Mvh hauge
hauge is offline  
January 16th, 2016, 11:56 AM   #10
Junior Member
 
Joined: Dec 2015
From: Norway

Posts: 22
Thanks: 2

I Ride:
My stator has black plastic that says "SEM" by the way.

Mvh hauge
hauge is offline  
Reply

  Husaberg Forum > Mechanical and Technical > Electrical

Tags
electrical, fe650, spark



Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
no spark! nikolz12 Electrical 4 March 31st, 2015 11:26 PM
No spark FE650 Husaleif Electrical 6 September 13th, 2012 10:14 AM
no spark 01 fe650 travism Electrical 9 May 28th, 2012 06:27 PM
2002 501 weak spark or no spark bergtime Electrical 3 December 11th, 2008 02:44 AM
no spark! Electrical 5 April 29th, 2004 04:00 PM


Facebook Twitter Google+ RSS Feed