FE570Ice

Went riding in the mountains yesterday and after 1hour riding my Berg dies and when i touch the starter to get the fuel pump running it didn´t .We took the tank of and took a look at the fuse and it was OK and also the plug for the gas tank.Than after a while the bike fired up and did run for 15min and then dies again so i had to bee towed to the car,today it fires right up.
What is the problem?Any suggestion?

dirty01

the same think happens to me 2 months ago ,when i riding the the berg dies ,after of many many many kics starts again but after 5 min dies again,i beleive your stator starts having problems

cimwill

I would check the wiring harness around the under side of the battery there is a bunch of harnesses with a holding clip it has to be run to clear the shock res. and the fuel pump mounting on the tank , I have had a short in this area caused by the protruding edge of the fuel pump mounting plate bolt on the tank pinching the harness here. After repairing the damaged wires I ended up using a heat gun to reshape the rear mud guard to give a little more clearance and ground the edges of the top of the mounting bolts , reassembled the tank, battery, seat etc then removed the tank again to make sure the wiring harness was not being pinched.

Chris

FE570Ice

Thanks for that gyus.
I went to the dealer and put plug the bike to a computer and it came with a code on the crankshaft.He did change the pulse generator on the crankshaft and the bike seems to be ok for now at least.I did also check the wiring harness around the tank and under the seat and it seems to be fine.